Surface Interactions during the Removal of Emerging Contaminants by Hydrochar-Based Adsorbents.

The aim of this work was to test activated carbons derived from hydrochars produced from sunflower stem, olive stone and walnut shells, as adsorbents for emerging contaminants in aqueous solution, namely fluoxetine and nicotinic acid. The adsorption capacity was determined by the chemical nature of the adsorbents, namely the presence of specific functional groups and their positive or negative ionization in aqueous solutions and also by steric factors. The activated carbons produced by air showed a higher adsorption capacity of fluoxetine, whilst the samples produced by carbon dioxide activation were more useful to remove nicotinic acid. In general, surface acidity was advantageous for fluoxetine adsorption and detrimental for nicotinic acid removal. The adsorption mechanisms involved in each case were discussed and related to the adsorbents characteristics. The maximum adsorption capacity, Q0, given by the Langmuir model was 44.1 and 91.9 mg g-1 for fluoxetine and nicotinic acid adsorption, respectively.

Magnetic Behavior of Carbon Materials Made from Biomass by Fe-Assisted Hydrothermal Carbonization.

Biomass magnetic materials were synthesized by several hydrothermal carbonization methods, by which iron was provided in different ways: as FeCl3 prior to or during hydrothermal carbonization, as pure Fe particles, or as magnetic ferrofluid, followed or not by pyrolysis processes. The materials were thoughtfully characterized in terms of elemental composition, thermal degradation, porosity (N2 adsorption, SEM micrography), surface chemistry (FTIR spectroscopy, XRD diffraction), and magnetization curves on a self-made installation. The results indicated that the process design can significantly improve the structure and chemistry of the material, as well as the magnetization effect induced on the adsorbent. Fe as FeCl3 was more interesting in regards to the development of porosity, mainly creating micropores, although it did not provide magnetism to the material unless a further pyrolysis was applied. Thermal treatment at 600 °C did not only increase the BET-specific surface (SBET) (262 m2 g-1) of the hydrochar, but also involved the transformation of Fe into magnetite, providing magnetic behavior of the hydrochar. Increasing pyrolyisis temperature to 800 °C even enhanced a better development of porosity (SBET of 424 m2 g-1) and also increased the specific magnetic susceptibility of the hydrochar as a result of the further transition of Fe into wustite and hydroxi-ferrite.

Modulation of CCL2 Expression by Laparoscopic Versus Open Surgery for Colorectal Cancer Surgery.

It is well known that surgery provokes an inflammatory response. However, the induced inflammatory response to laparoscopic compared with open surgery under combined anesthesia has never been compared following colorectal cancer surgery. We hypothesize that laparoscopic technique under general anesthesia results in a decreased proinflammatory state. We compared cytokines plasma secretion after laparoscopic technique under general anesthesia (LG), open surgery under combined anesthesia (thoracic epidural and general anesthesia) (OGE), and open surgery under general anesthesia as the control group (OG). Proinflammatory cytokines measured postoperatively were significantly increased in the OG group (n=19), compared with the LG (n=18) and OGE (n=20) groups. Post hoc analysis showed that CCL2 levels were significantly lower in LG at all times postoperatively (P<0.01), while interleukin-4, an anti-inflammatory cytokine, was increased in the OGE group (P<0.01). Laparoscopic technique blunts the postoperative proinflammatory response from the very early stages of the inflammatory cascade, whereas combined anesthesia is a more anti-inflammatory approach.

Removal of amitriptyline from simulated gastric and intestinal fluids using activated carbons.

In this work, the adsorption behavior of a tricyclic antidepressant, amitriptyline hydrochloride, onto several activated carbons (ACs) is reported. The adsorption was done using in vitro simulated gastric and intestinal fluid at 37°C to test the performance of the carbons as treatment in overdose cases. The tested materials were one commercial AC (carbomix) and two ACs produced in our laboratory. The highest adsorption capacity was achieved by carbomix, followed by the laboratory-made carbons that still have a very good performance with adsorption capacity up to 120 and 100 mg/g for the gastric and intestinal fluids, respectively.